Operation Manual
5
Liquid Propane (LP) Safety Information
General Information
• This grill is designed certified by ETL for use with a 
standard 20 lb. LP gas cylinder.
• This grill CANNOT be converted to natural gas. 
 DO NOT attempt to convert this grill with a different 
gas type.
Safety Information
• LP gas has an odor similar to natural gas.
• LP gas is heavier than air and leaking gas may collect 
in low areas and resist dispersion.
•  LP cylinders should not be dropped or handled 
roughly.
• DO NOT use a damaged LP cylinder. A dented or 
rusty LP cylinder or an LP cylinder with a damaged 
valve may be hazardous and should be replaced with 
a new cylinder immediately. 
• ALWAYS close the cylinder valve after use.
• ALWAYS close the cylinder valve when disconnecting 
the regulator. 
 • ALWAYS treat possible empty LP cylinders with the 
same care as a full LP cylinder. There may still be gas 
pressure inside a possible empty LP cylinder.
• NEVER store or transport an LP cylinder where the 
temperature can reach 125ºF.
• Keep LP cylinders away from children and pets.
• DO NOT store disconnected LP cylinders in a 
building, garage or other enclosed areas.
• If the LP cylinder is kept in the grill between 
uses, make sure to keep both the grill and 
the cylinder in an outdoor area with good 
ventilation.
• ALWAYS leak test the LP cylinder 
connection to the regulator when ever 
changing LP cylinders.
Installation of LP Cylinder
1. Make sure all burner controls are in the OFF 
position.
2. Open the cabinet door.
3. Carefully position in the large hole on the 
bottom panel.
4. To secure the LP cylinder in place, screw the 
tank holding tray bolt through the bottom 
section of the LP cylinder.
5. Attach the regulator to the cylinder by 
carefully HAND TIGHTENING only.
6.    NEVER  use a wrench or other tool to tighten 
this connection.
7. Observe all governing codes and 
ordinances.
Important
The United States LP gas appliance installation 
must conform with local codes and ordinances. 
In the absence of local codes, appliance 
installation must conform with either the 
National Fuel Gas Code, ANSI Z223.1/NFPA54, 
Natural Gas and Propane Appliance code, 
CSA B149.1, or Propane Storage and Handling 
Code, B149.2, as applicable.
For Canada, installation of this grill must comply 
with local codes and/or Standard CSA B149.2 
(Propane Storage and Handling Code).
Please review the below guidelines and safety information when using Liquid Propane (LP) gas.










