Installation Instructions

DECK SLEEVES
INSTALLATION
1. Landmark Accents™ Deck Sleeves
are designed to slip over a
6” x 6” treated post or can be used
with a shimmed 4” x 4” post.
1a. Shim 4” x 4“ treated post with a
minimum 1” and a
maximum 1 5/32” x 6”
deck board.
1b. Full length shims should
be used on the sides
to which railing will
be attached.
1c. Short shims (6” x 6” used
as spacers top and bottom)
should be used on the sides
where no railing will be
attached.
2. Slide deck sleeve over post to the deck base.
Refer to the railing manufacturer for
approved fastening method
making sure that fasteners
penetrate the deck board/post.
3. Secure deck sleeve cap by applying a
quality polyurethane exterior
adhesive to the top edge of
the deck sleeve. Center cap
and apply pressure to
secure.
4. Fill any voids
around top and
bottom rails and/or
rail brackets with
color matching
exterior caulk
available through Menards
Floor Coverings Department.
Available
DECK SLEEVES & CAP
LBR844-BX
Brick Bordeaux
8" x 8" x 44"
LPS844-TS
Stucco Tan
8" x 8" x 44"
LCS844-ST
Cobblestone
Summer Tan
8" x 8" x 44"
LCFF10 Flagstone Cap 10" x 10" x 2 1/2"
For more information go to web site
www.landmarkaccents.com
Architectural Composite Technologies
2500 Marina Drive • Elkhart, IN 46514
Note: Saw, drill or route for
limitless unique applications
(If using 6” x 6” post go to Step 2)