Owner manual

ASSEMBLY INSTRUCTIONS

3-9

Figure 3-7: Optional Accessories Installation

Ridgers

A ridger is an optional device that can be installed on

each shank.

1. Full ridgers should be installed on the inner shanks,

and half ridgers should be mounted on the outer, end

shanks. (Half ridgers should be inside of the tool

assembly.)

2. Assemble a shank clamp (See Figure 3-7) to the

rear of each shank. Secure the bracket with u-bolts

and 5/8-11 hex lock nuts.

Anhydrous Ammonia Knives

1. The ammonia knives are mounted in the same

manner as the ridgers. They cannot be used at the

same time the ridgers are being used (See

Figure 3-7.)

Fertilizer Tubes

1. The fertilizer tubes should be mounted on the disc

shaft assemblies. Secure with a u-bolt and 5/16-18

hex lock nuts (See Figure 3-7.)

IMPORTANT

Be sure to raise the tubes high enough to clear the

ground to prevent plugging the tubes.

SHANK

U-BOLT

OFFSET DISC

ASSEMBLY

AMMONIA KNIFE

ASSEMBLY

IRRIGATION RIDGERS

(OPTION)

FERTILIZER ATTACHMENT

5/16-18 HEX LOCK NUT

FERTILIZER TUBE

ASSEMBLY

PLASTIC TUBE END

5/8-11 HEX LOCK NUT

RIDGER ASSEMBLY

545m104602