2131 Wing Coulter Chisel User Manual

3-12 F-721-0513 Edition
ASSEMBLY INSTRUCTIONS
Coulter Gang Installation

DANGER
1. Attach the coulter ga ng assemblies to the cen ter and
wing frames using shank pin, 1-8 hex lock nut, and
1/2 x 2-1/4 grooved alloy pin (See Figure 3-7.)
2. Attach the base end of the 4 x 8 master cylinder to
the coulter spring ro d as se mb ly at tached to the left
wing frame weldment using the clevis pins and roll
pins which come with th e cylin de r and a steel
bushing.
3. Att ach the base end of the 3-3/4 x 8 slave 1 cylinder
to the coulter spring rod assembly att ached to the lef t
center frame weldment using the clevis pins and roll
pins which come with the cylinder and a steel
bushing.
4. Att ach the base end of the 3-1/2 x 8 slave 2 cylinder
to the coulter spring rod assembly attached to the
right center frame weldment usin g the clevis pins and
roll pins which come with the cylinder and a steel
bushing.
5. Att ach the base end of the 3-1/4 x 8 slave 3 cylinder
to the coulter spring rod assembly attached to the
right wing frame weldment using the clevis pins and
roll pins which come with the cylinder and a steel
bushing.
6. Connect the rod ends of each cylinder to the gang
bar cylinder anchor plate using the clevis pins and
roll pins which come with each cylinder.
7. Install 90
o
adapters into both ports of the 4 x 8
master cylinder, 3-3/4 x 8 slave 1 cylinder, 3-1/2 x 8
slave 2 cylinder, and the base end po rt of the 3- 1/4 x
8 slave 3 cylinder.
8. Install 90
o
elbow w/ restrictor into the rod end of the
3-1/4 x 8 slave 3 cylinder.
Coulter blades are extremely sharp. Exercise
extreme care when working on or near coulter
blades. Do not allow coulters to roll over or fall
onto any body p art. Do not allow wrenches to slip
when working near coulter blades. Never push
wrenches toward coulter blade s. Do not climb
over machine above coulter blades. Failure to
stay clear of coulter blade edges can cause
serious personal injury or death.