2131 Wing Coulter Chisel User Manual

3-28 F-721-0513 Edition
ASSEMBLY INSTRUCTIONS
Light Installation
NOTE
See Figures 2-1 thru 2-16 for light bracket placement. If
no dimension is given for a bracket, it should be located
against frame member as shown in drawing.
1. Attach inner tail light mounting bracket supports to
the center frames using 1/2-13 x 8-1/2 hex head cap
screws, warning light bars, an d he x lock nuts (See
Figure 3-19.)
2. Connect enhanced lighting module to the right inner
tail light bracket using #8-32 x 1/2 slotted pan head
screws and hex nut.
3. Attach outer lh and rh light brackets to frame
weldment using 1/2-13 x 5-1/2 he x head cap screws,
warning light bars, and hex lock nuts.
IMPORTANT
Outer light brackets need to be slid rearward as far
as possible. See Figures 2-1 thru 2-16 for light
bracket placement.
4. Attach red brake lamps to inner tail light mounting
bracket supports and amber lamps to outer light
brackets using 1/4-20 x 1-1/4 hex head cap screws
and hex lock nuts.
5. Connect warning light harnesses to lights.
6. Attach SMV emblem and mounting bracket to rear
center frame bar using warning light bar, 1/2-13 x
5-1/2 hex head cap screws, 1/4-20 x 3/4 hex head
cap screws, and hex lock nu ts. The SMV sig n should
be centered on the rear bar of the frame.
7. Attach red, orange, and yellow reflectors to outer rh
and lh tail light mounting brackets.
Figure 3-20: 1,200 Foot-Pounds of Torque
Final Assembly
1. Attach a tractor to the implement and charge the lift
system hydraulics as described in “Hydraulic Lift
System” on p age 4-2.
2. Install the 2 x 16 transport lockouts on both 4-1/2 x
16 master cylinders on the center frame.
3. The fold systems must be purged of air and filled with
oil BEFORE attempting to fold the implement. Air in
the system will allow the wings to fall uncontrollably
and may result in implement damage. Follow
instructions for char ging th e hydr aulic fold system as
described in “Hydr aulic Fold Syst em” on p a ge 4-4.
4. Connect lights to the tractor and verify operation.
5. Check tires for proper inflation
6. Level the Wing Coulter Chisel from front to rear as
described in “Leveling (Front-to-Rear)” on
page 4-7.
7. Inspect the final implement assembly, and verify that
all bolts ha ve been tightened, cotter pins spread, and
that there are no leaking hydraulic connection s.

CAUTION
8. Rot ate each coulter gang to verify that each gang
rotates freely. Adjust any scrapers that may have
shifted during shipment or assembly.
9. Lubricate the Wing Coulter Chisel at all locations as
described in “Lubrication Maintenance” on
page 4-16.
10. Touch up with paint any areas that may have been
scratched during moving, handling, or assembly.
11. Thoroughly read and understand the operating
section before using the Coulter Chisel.
300
POUNDS
PULL
4 FOOT
torque ft lbs
Tighten all 1-3/4” nuts to 1,250 foot-pounds of
torque (See Figure 3-20.)