User Manual

3-12 F-733-0114 Edition
ASSEMBLY INSTRUCTIONS
Figure 3-10: Depth Stop Tube Installation
Depth Stop Tube Installation
1. Attach the depth control mount plate to the lift using
3/8-16 x 1-1/4 hex head cap screws and hex lock
nuts.
2. Lay the depth stop tube assembly on top of the
center frame. Insert a 5/8- 11 x 2-1/2 hex head cap
screw in the rear hole of the tube assembly from the
left side (See Figure 3-10.) Install a 5/8-11 hex nut
on the screw. Do not over tighten, as the depth stop
must pivot o n this screw . I nsert the screw through the
depth stop mounting plate on the center lift and
secure with a 5/8-11 hex lock nut.
3. Insert 90º
elbow fitting in the front of the limit valve.
4. Using 5/16-18 x 5 hex head cap screws secure the
front end of the depth stop tube assembly to the top
of the frame mount with the depth stop guide, slide
pad, and 5/16-18 hex lock nu ts. Attach the limit valve
to the bottom side of the center frame mount using
these same scre ws .
IMPORTANT
It may be necessary to leave these screws loose to
attach the valve hoses later.
6250-depth stop tube op
3/8-16 HEX LOCK NUT
DEPTH STOP TUBE
ASSEMBLY
5/16-18 X 5 HEX
HEAD CAP SCREW
DEPTH STOP GUIDE
SLIDE PAD
5/8-11 HEX LOCK NUT
5/8-11 X 2-1/2 HEX
HEAD CAP SCREW
DEPTH CONTROL MOUNT
3/8-16 X 1-1/4 HEX
HEAD CAP SCREW
90 ADAPTER
LIMIT VALVE
5/16-18 HEX
LOCK NUT