User's Manual

1 2 3 4

7 8 9 10 12

The Mic input is designed for low impedance microphones, it is a balanced XLR socket so will work equally well with

microphones that are balanced or unbalanced. Level controlled by

The Line In socket is designed for line level signals such as those obtained from keyboards, sound modules and sounds cards.

Level controlled by Both mic and line in sockets may be used at the same time.

This gain control allows you to adjust the audio level of instruments connected to the Channel 1 Mic and Line In sockets.

Bass control for channel 1, Low/Bass frequencies can be boosted or cut by this control . Sources that fall in this range are

bass guitar, kick drums, deep vocals and keys below middle C on a keyboard.

Treble control for channel 1, High/Treble frequencies can boosted or cut by this control. Sources that fall in this range are

cymbals, soprano vocals and keys above top C on a keyboard.

Switch in to assign reverb signal to channel 1, the overall reverb level is controlled by

RCA Phono socket for the connection of line level equipment like CD Players etc. Level controlled by

1/4” Jack socket designed to accept any line level signals from equipment such as keyboards, sound modules, CD/MP3 players

and sounds cards. Level controlled by Both CD and line in sockets may be used at the same time.

Page 6 /12

FRONT PANEL CONTROLS

Laney

OPERATING INSTRUCTIONS

11 13

This gain control allow you to adjust the level of instruments connected to the Channel 2 CD In and Line In sockets.

1/4” Jack socket designed to accept any line level signals from equipment such as keyboards, sound modules, CD/MP3 players

and sounds cards. Level controlled by

This gain control allow you to adjust the level of instruments connected to the Channel 3 Line In socket.

Bass control for Channel 2 and 3, Low/Bass frequencies can be boosted or cut by this control such as bass guitar, kick drums,

deep vocals and keys below middle C on a keyboard.

Treble control for Channel 2 and 3, High/Treble frequencies can boosted or cut by this control. Sources that fall in this range

are cymbals, soprano vocals and keys above top C on a keyboard. Switch in to assign reverb signal to this channel.

Switch in to assign reverb signal to channels 2 and 3, the overall reverb level is controlled by

The AH100 has a built in spring line reverb, the level of reverb effect is determined by this control. It will have no effect until

you assign reverb to a channel with either or

Control the overall sound level from the amplifier.

This socket provides a balanced low-impedance output-signal from the pre-amplifier taken before the Master Volume but after

any tone correction, used for direct-injection of the amplifier signal to a mixing-desk or additional power-amplifier.

Indicates power is connected and the amplifier is switched on.

(Always switch off and disconnect power cord when not in use)

Main power on/off switch.

6 14

Page 7 /12

Laney

OPERATING INSTRUCTIONS

15 16 1917

1814