User's Manual

Page 8 /12
Laney
OPERATING INSTRUCTIONS
Your AH100 features a kick style design to enable you to use it as a stage monitor, or a conventional straight combo.
Page 9 /12
OTHER FEATURES
SAMPLE SYSTEM
Laney
OPERATING INSTRUCTIONS
3 4 5
Power inlet socket. Connect to your power source. Make sure the specified voltage is correct for your country!
This drawer contains the main safety fuse for the unit.
USE ONLY THE CORRECT SIZE AND RATING OF FUSE AS SPECIFIED ON THE PANEL.
The mains fuse ratings are detailed in the specs section at the rear of this manual.
Serial Number and model of your unit.
This socket(s) should be used to connect an extension-cabinet. The impedance of the extension-cabinet must not be less than
8 Ohms. Connecting cabinets that have a lower impedance than 8 Ohms will result in the amplifier overheating. Continual use
in this manner may cause permanent damage. Connecting a cabinet with an impedance of greater than 8 Ohms will cause no
damage to the amplifier but will result in a reduced output level. (When using an extension cabinet the internal speaker remains
connected)
This is for the connection of headphones for private listening, connecting headphones here disconnects the internal
loudspeaker.
By connecting a Laney FS1 footswitch (Not included) here you can remotely switch the reverb on / off. This is a useful facility
as it allows you to switch the reverb off between songs during a gig.
1
2
3
FRONT PANEL CONTROLS
4
6
5
6
1 2