Laney HCP804 USER MANUAL
Intended to alert the user to the presence of uninstalled "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Intended to alert the user of the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. Caution: Risk of electrical shock - DO NOT OPEN! Caution: To reduce the risk of electrical shock, do not remove cover. No user servicable parts inside.
Laney 1 1. INTRODUCTION Congratulations on your decision to purchase a Laney amplifier. Laney products are designed with ease of operation as a primary objective, however to ensure you derive the best from your new amplifier, it is important you take time to read this user manual and to familiarise yourself with the control functions and facilities available BEFORE SWITCHING ON After unpacking your amplifier check that it is factory fitted with a three pin 'grounded' (or earthed) plug.
Laney 2 1.
Laney 1. 3 HCP804 Master Section 9 6 7 8 BASS: Controls the low frequency EQ in the over all signal. VOLUME: Controls the overall listening volume of the amplifier. MAIN: A line level output, for connection to another amplifier or desk, etc. This takes the signal from after the ‘Master’ volume control, unlike the ‘Rec Out’, which is unaffected by the overall listening level of the amp.
Laney 4 HCP804 Rear Panel 16 17 18 SPEAKER OUTPUTS: Twin jack sockets for connection of loudspeaker cabinets. The HCP804 will deliver 80 watts of output power into a 4 ohm load. Under no circumstances should the total load seen by the amp fall below 4 ohms. This would result in temporary thermal shutdown, which, after continued use under these conditions, may impair the long term reliability of the amplifier.
