User's Manual

8 9

ENG

2. START-UP GUIDE

Open the rear cover. Lift up to unlock hooks.

Install the three filter cartridges.

1. Sediment Filter

2. Activated Carbon

3. RO Membrane

When done, push each lever down until it locks.

Make sure the levers are tightly locked to avoid water spray or leakage.

Push the levers up to install filter cartridges.

Re-install the rear housing cover.

Before using TheWell for the first time, you’ll need to complete the Setup Process, which takes about xx minutes. TheWell’s display will guide you

through the steps, and the following section explains them in detail.

2.1. INSTALLING THE FILTERS

The system has three filters. All three are required for operation.

2.2. INSERTING THE LANGPAK CONTAINERS (MINERALS AND FLAVOR)

The system has three LANGPAK slots. Two containers are required (Mineral A and Mineral B)

and one is optional (flavor).

To open the top lid, press gently on the back part of the lid.

Install LANGPAK Mineral A in the slot marked “A”.

Install LANGPAK Mineral B in the slot marked “B”.

IMPORTANT: TheWell machine will only operate when both Mineral A and Mineral B contain-

ers are inserted. TheWell will also detect when the mineral containers are empty and will

stop operating until they are replaced.

Optional: install a LANGWATER+ flavor container in the slot marked “C”

IMPORTANT: Push the containers down until they lock firmly in position.

Close the top lid after minerals and flavor containers are installed.

IMPORTANT: If the top lid does not close completely, it means that one or more of the

LANGPAK containers is not properly inserted. Remove and reinsert the containers, pushing

them down firmly so they lock.