Installation & Assembly

CONNECTING TOP PANEL TO BASE

Page 2 of 2

STEP :

. Take out the hardware package from the carton of Base (2).

2. Adjust each four holes of the bottom of Top (1) and Base (2) to be matched ,then insert 1 piece Bolt

(A) with 1 piece Washer (B) into one of the matched holes of the bottom of Top (1) and Base (2) but

don’t tighten fully at this step.Insert other 3pieces Bolt (A) with 3 piece WasherS (B) into matched

holes,pls also don’t tighten fully.

3. Make sure all four pieces Bolts (A) with Washers (B) insert into holes and tighten all Bolts(A) by

using Allen Wrench(C) fully.

Assembly is complete. Your Table is ready to enjoy now!