Printer User Manual
Table Of Contents
- AP2610 Printer Reference
- Trademarks
- Manuals for This Printer
- How to Read This Manual
- TABLE OF CONTENTS
- 1. Setting Up the Printer Driver and Canceling a Print Job
- PCL 6/5e - Accessing the Printer Properties
- RPCS - Accessing the Printer Properties
- PostScript - Setting Up for Printing
- Canceling a Print Job
- 2. Uninstalling the Printer Driver and Software
- 3. Paper and Other Media
- 4. Sample Print/Locked Print
- 5. Troubleshooting
- 6. Making Printer Settings with the Control Panel
- 7. Appendix
- INDEX
Paper and Other Media
48
3
D
DD
D
Push the bottom plate down until
it locks into place.
E
EE
E
Load envelopes into the Envelope
Feeder Unit, with the print side
down and the flap on the left as
shown in the illustration.
Important
❒ Confirm that the envelope flaps
are securely folded down, and
that there is no air inside the en-
velopes.
Note
❒ Confirm that the top of the stack
is not higher than the limit mark
on the side guides.
❒ Confirm that the envelopes fit
under the side guides.
❒ Do not push the stack of enve-
lopes with too much force.
F
FF
F
While pinching the side guides,
slide them along the edge of the
envelope stack.
G
GG
G
While pinching the rear guide,
slide it along the edge of the enve-
lope stack.
H
HH
H
While lifting the front of the tray,
place it into the printer. Then
slide it until it stops.
Important
❒ Do not slide the paper tray in
with force. If you do, the front
and side guides might move.
ZDDP360E
ZDDP380E
ZGDY370E
ZGDY390E