User's Manual

User Manual
WCB1000H5PX/WCB1010H5PX IEEE802.11bg High Power BS/Bridge/CPE
95
6.3.1 IP Rule Setup
The administrator can setting IP Filter via this page, Please click on Firewall -> IP Rule Setup and follow the below
setting.
 Source Address/Mask : Enter the desired source IP address and netmask; the mask must be a plain number,
i.e. 192.168.2.10/32
 Source Port : The source port(s) required for this rule. A single port may be given, or a range may be given as
start:end , which will match all ports from start to end, inclusive.
 Destination Address/Mask : Enter the desired destination IP address and netmask; the mask must be a plain
number, i.e. 192.168.1.10/32
 Destination Port : The destination port(s) required for this rule. A single port may be given, or a range may be
given as start:end , which will match all ports from start to end, inclusive.
 In/Out : This option used for specialized packet alteration. The system support In (INPUT : for packets coming
into the interface itself) or Out (FORWARD : for altering packets being routed through the interface)
 Protocol : This option allows you to select protocol type. The system support TCP, UDP or ICMP.
 Listen : Enable Yes to match TCP packets only with the SYN flag.
 Active : Enter Deny to DROP specialized packet; Pass to ACCET the specialized packet
 Side : Select specified interface via which a packet was received.
 Save : Click Save button to activate the new creation.