User's Manual

User Manual
AP981X/AP981WX In-Wall Poe Wireless-G AP/Bridge
4.2.1 General Setup
The administrator can change the data transmission, channel and output power settings for the
system. Please click on Wireless -> General Setup and follow the below setting.
 MAC address : The MAC address of the Wireless interface is displayed here.
 Band Mode : Select an appropriate wireless band; bands available are 801.11b, 802.11g and
802.11b+802.11g.
 Transmit Rate Control : Select the desired rate from the drop-down list; the options are auto or
ranging from 1 to 54Mbps for 802.11g and 802.11b/g modes, or 1 to 11Mbps for 802.11b mode.
Note : Trying to Adjust Transmit Rate Control for long distance links, WDS link may be
get better throughput.
 Country : Select the desired country code from the drop-down list; the options are US, ETSI and
Japan.
 Channel : The channel range will be changed by selecting different country code. The channel
range from 1 to 11 for US country code, or 1 to 13 for ETSI country code, or 1 to 14 for Japan.
 Tx Power : You can adjust the output power of the system to get the appropriate coverage for
your wireless network. Select the LEVEL 1 to LEVEL 9 you needed for your environment. If you
are not sure of which setting to choose, then keep the default setting, LEVEL 9.
Change these settings as described here and click Save button to save your changes. Click Reboot
button to activate your changes. The items in this page is for WDS's RF general settings and will be
applied to all WDS Links.
60