Product Info
Table Of Contents
- 1 Introduction
- 2 Applicable Module
- 3 Additional Regulatory Conformance Testing and/or Submissions Required by the Integrator
- 4 Compliant/Allowable Tx Power Settings
- 5 Allowable Antennas to use with the Radio Module
- 6 Antenna Placement inside the Host System and RF Safety
- 7 Simultaneous Transmission with other Integrated or Plug-in Radios
- 8 Module May Not Be Installed by End Users
- 9 Required Labeling on the Outside of the Host
- 10 Required Labeling on the Module
- 11 Required Regulatory Wording for User Manual/Installation Manual
- 12 OEM Integrator Checklist
Title
Date
Originated
15-Nov-
182015
Revision:
C
INTRINSYC TECHNOLOGIES
CORP.
Doc #: ITCNFA324-IG-001
Date Revised:
30-Nov-2018
1
Intrinsyc – Confidential Information
1 Introduction
This document describes the steps that the OEM integrator must follow when designing and manufacturing a system
utilizing the ITCNFA324 Module.
Failing to follow the instructions in this document may invalidate the FCC certification and authorization of the
Module for use in the U.S. and other countries.
The Module certifications described in this document apply only to radio conformance for the Module. The OEM
integrator is responsible for all system-level EMI/EMC and Product Safety testing and certifications that apply to the
host system in the U.S. and other countries where the system will be marketed or sold.
2 Applicable Module
• Part Number: NFA324 (Regulatory model: ITCNFA324)
• FCC ID: 2AFDI
-ITCNFA324 IC: 9049A-ITCNFA324
3 Additional Regulatory Conformance Testing and/or Submissions
Required by the Integrator
• The modular certifications apply to the radio conformance for the Module only.
The OEM integrator is responsible for additional system-level EMI/EMC and Product Safety testing and
certification that applies in the U.S. and other countries to the host system containing the Module. This
includes but is not limited to Federal Communications Commission (“FCC”) Part 15 Class B Digital
Emissions.
These system-level EMC tests are to be done with the Module installed and included in the scope of the
submission.
• Some of the countries for which modular certifications are provided require additional submissions,
authorizations or import permission by the system-vendor or importer. The integrator is responsible for
these additional actions.
• Modular radio certification is not possible in some countries. For such countries, OEM integrators must
ensure radio certification for the end system is obtained, before placing the product on the market.
4 Compliant/Allowable Tx Power Settings
Any adjustments made to increase transmit power settings will invalidate all radio certifications for this module.
5 Allowable Antennas to use with the Radio Module
The module is certified for use with certain antennas as described in this section.
Allowed Antenna Types:
1. PIFA with omnidirectional pattern formed from stamped metal or film.
2. Dipole antenna
3. Chip antenna
4. Kontron WiFi Flag Antenna P/N: 730001001