Product Info
Table Of Contents
- 1 Introduction
- 2 Applicable Module
- 3 Additional Regulatory Conformance Testing and/or Submissions Required by the Integrator
- 4 Compliant/Allowable Tx Power Settings
- 5 Allowable Antennas to use with the Radio Module
- 6 Antenna Placement inside the Host System and RF Safety
- 7 Simultaneous Transmission with other Integrated or Plug-in Radios
- 8 Module May Not Be Installed by End Users
- 9 Required Labeling on the Outside of the Host
- 10 Required Labeling on the Module
- 11 Required Regulatory Wording for User Manual/Installation Manual
- 12 OEM Integrator Checklist
Title
Date
Originated
15-Nov-
182015
Revision:
C
INTRINSYC TECHNOLOGIES
CORP.
Doc #: ITCNFA324-IG-001
Date Revised:
30-Nov-2018
6
Intrinsyc – Confidential Information
11 Required Regulatory Wording for User Manual/Installation Manual
The OEM integrator must include text in the user manual meeting the regulators’ requirements. The text below or
similar wording should be used. (Text in red font must be replaced.)
FCC compliance information 11.1
This device complies with Part 15 of the FCC Rules. Operation is subject to the following to conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This product does not contain any user serviceable components. Any unauthorized product changes or modifications
will invalidate warranty and all applicable regulatory certification and approvals, including authority to operate this
device.
FCC Part 15 Digital Emissions Compliance
We [System Manufacturer Name, Address, Telephone], declare under our sole responsibility that the product
[System Name] complies with Part 15 Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
WARNING: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates and radiates radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the use is encouraged to try to correct the interference by one of more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from the one the receiver is connected to.
• Consult the dealer or an experienced radio.TV technician for help.
(Notice for 5GHz and/or when co-located with 5GHz transmitters, the following statements should be
provided for user information.)
Operations in the 5.15-5.25GHz band are restricted to indoor usage only. (For 5GHz only)
(RF exposure statement)
Radiation Exposure Statement
The product comply with the FCC portable RF exposure limit set forth for an uncontrolled environment and are safe
for intended operation as described in this manual. The further RF exposure reduction can be achieved if the product
can be kept as far as possible from the user body or set the device to lower output power if such function is
available.