Use Instructions

PN 10232 Eagle V1.2 Instructions for Use Rev 1.0 Page 93 of 101
Table 42 External Communications Hub Wireless Instructions
10.
“Device 2 is ready for wireless, unplug Device USB cable”.
Unplug HFC USB Cable 90° Type-C connector from the second HFC.
11.
ECH notifies “Hub Setup Complete”
12.
Review the HFC Display Screen.
Connected Handheld Fluorescent Camera(s) will show “ECH:
Connected Wifi” in the top.
13.
Press “Enable Casting” to cast the HFC Display Screen onto the ECH
Display Monitor Wirelessly.
14.
Verify the ECH Display Monitor is casting the HFC Display Screen.
6.3.2.3. ECH Wired Configuration
Table 43 External Communications Hub Wired Instructions
1.
Ensure the ECH has been assembled and is powered on according to section 6.3.2.1.
2.
After ECH PC power on, enter authorization PIN on ECH Numeric Pad to login.
3.
After successful login, the ECH Display Monitor shows the ECH Start
Up screen.
4.
Shortly after, ECH prompts to “Insert & Unlock USB Memory Stick”.
Insert ECH Flash Drive into the ECH PC USB port and/or unlock
encrypted ECH Flash Drive.
5.
When ECH Flash Drive is unlocked and plugged into the ECH PC USB
port, ECH notifies “USB memory stick setup complete”.
6.
After successful login, ECH notifies “Hub is ready for Wired setup –
Connect First Device”.