User Guide
9: Setup Mode: Advanced Settings
Default Settings (Option 7)
Select 7 to reset the unit’s channel configuration and expert settings to the default settings.
The server configuration settings for IP address, gateway IP address, and netmask remain
unchanged. The specific settings that this option changes are listed below:
Channel 1 and Channel 2 Configuration Defaults
Channel Setting Default Configuration
Baudrate
9600
I/F Mode
4C (1 stop bit, no parity, 8 bit, RS-232C)
Flow
00 (no flow control)
Port number
10001 (channel 1)
10002 (channel 2)
Connect Mode
C0 (always accept incoming connection; no active
connection startup)
Send '+++' in Modem Mode
Enabled
Show IP addr after 'RING'
Enabled
Auto increment source port
Disable
Hostlist retry counter
3
Hostlist retry timeout
250 (msec)
Start character for serial channel 1
0x0D (CR)
All other parameters
0
Expert Settings Defaults
Expert Setting Default Configuration
TCP Keepalive time in s
45
ARP Cache timeout in s
600
Disable Monitor Mode @ bootup
No
HTTP Port Number
80
MTU Size
0 (resulting in an operational value of 1400)
TCP Re-Transmission Timeout
(500-4000)
500 (ms)
Alternate MAC
Disabled ( for OEM use only)
Ethernet Connection Type
0 (auto-negotiate)
Micro125 User Guide 61