User guide

EDS1100/2100 User Guide 41
8: Line and Tunnel Settings
This chapter describes how to view and configure lines and tunnels. It contains the following
sections:
 Line Settings
 Tunnel Settings
Line Settings
You can view statistics and configure the serial interfaces (referred to as lines) by using the Line
web page. When you click Line from the Main Menu, Line 1 fields display. To go to Line 2, click
the Line 2 button.
The following sub-menus you can use:
 Line Statistics—Displays statistics for the two lines. For example, the bytes received and
transmitted, breaks, flow control, parity errors, etc.
 Line Configuration—Enables the change of the name, interface, protocol, baud rates, and
parity, etc.
 Line Command Mode—Enables the types of modes, wait time, serial strings, signon
message, etc.
Line Statistics
To display the line statistics, perform the following steps.
1. Click Line on the Main Menu. Figure 8-1 shows the page that displays.