User guide

ManualsBrandsLantronix ManualsOtherEDS1100

Table Of Contents

EDS1100/2100 User Guide
- Copyright and Trademark
- Warranty
- Contacts
- Disclaimer and Revisions
- Compliance
- Revision History
- Table of Contents
1: About This Guide
- Chapter Summaries
- Conventions
- Additional Documentation
2: Overview
- Key Product Features
- Applications
- Protocol Support
- Evolution OS™
- Software Features
- Configuration Methods
- Addresses and Port Numbers
- Product Information Label
3: Installation of EDS1100
- Package Contents
- User-Supplied Items
- Hardware Components
- Installing the EDS1100
4: Installation of EDS2100
- Package Contents
- User-Supplied Items
- Hardware Components
- Installing the EDS2100
5: Using DeviceInstaller
- Accessing EDS1100/2100 using DeviceInstaller
- Device Details Summary
6: Configuration Using Web Manager
- Accessing Web Manager
  - Device Status Page
- Web Manager
- Navigating the Web Manager
7: Network Settings
- Network 1 Interface Status
- Network 1 Interface Configuration
- Network 1 Ethernet Link
8: Line and Tunnel Settings
- Line Settings
- Tunnel Settings
9: Terminal and Host Settings
- Terminal Settings
  - Network Terminal Configuration
  - Line Terminal Configuration
- Host Configuration
10: Services Settings
- DNS Status and Cache
- PPP Configuration
- SNMP Configuration
- FTP
- TFTP
- Syslog
- HTTP
- RSS
- LPD
  - LPD Statistics
  - LPD Configuration
11: Security Settings
- SSH Server Host Keys
- SSH Server Authorized Users
- SSH Client Known Hosts
- SSH Client User Configuration
- SSL Cipher Suites
- SSL Certificates
- SSL RSA or DSA
- SSL Certificates and Private Keys
- SSL Utilities
- SSL Configuration
12: VIP
- Obtain a Bootstrap File
- Import the Bootstrap File
- Enable VIP
- Configure Tunnels to Use VIP
- VIP Statistics
- VIP Configuration
13: Maintenance and Diagnostics Settings
- Filesystem
  - Filesystem Statistics and Actions
  - Filesystem Browser
- Protocol Stack
  - TCP
  - IP
  - ICMP
  - ARP
- IP Address Filter
- Query Port
- Diagnostics
- System
14: Advanced Settings
- Email Statistics
- Email Configuration
- Command Line Interface
  - CLI Statistics
  - CLI Configuration
- XML Configuration
15: Branding the EDS1100/2100
- Web Manager Customization
- Short and Long Name Customization
16: Updating Firmware
A: Technical Support
B: Binary to Hexadecimal Conversions
- Converting Binary to Hexadecimal
  - Conversion Table
  - Scientific Calculator
C: Compliance
Index

8: Line and Tunnel Settings

EDS1100/2100 User Guide 52

Accept Mode supports the following protocols:

 SSH (EDS1100/2100 acts as the server). When using SSH, the SSH server host keys and at

least one SSH authorized user must be configured.

 SSL

 TCP

 AES encryption over TCP

 Telnet (EDS1100/2100 supports IAC codes. It drops the IAC codes when Telnetting and does

not forward them to the serial port).

Accept Mode has the following states:

 Disabled (never a connection)

 Enabled (always listening for a connection)

 Active if it receives any character from the serial port

 Active if it receives a specific (configurable) character from the serial port (same start

character as Connect Mode’s start character)

 Modem control signal

 Modem emulation

To configure Accept Mode, perform the following steps.

1. Click Tunnel 1 > Accept Mode. Figure 8-14 shows the page displays.