User guide

8: Line and Tunnel Settings
EDS1100/2100 User Guide 59
Figure 8-18 Host Mode
Host Mode controls how multiple hosts operate in Connect Mode. The following options are
available:
 Sequential—A Tunnel to the first host is attempted. If the connection fails, the next host
specified is attempted. This will continue until a connection is made. If a connection is dropped
after a successful connection has been established, tunnel connection attempts begin again
from the first host.This is the default.
 Simultaneous—Tunnel connects to all of the hosts that accept a connection.
To configure Host 2 and other hosts up to a maximum of 16, perform the following steps.
1. Click <None> in the Host 2 field. Figure 8-19 shows the page that displays.