User's Manual

5: Commands and Levels
tx data rate maximum mcs1
Sets the data rate maximum to MCS1.
tx data rate maximum mcs2
Sets the data rate maximum to MCS2.
tx data rate maximum mcs3
Sets the data rate maximum to MCS3.
tx data rate maximum mcs4
Sets the data rate maximum to MCS4.
tx data rate maximum mcs5
Sets the data rate maximum to MCS5.
tx data rate maximum mcs6
Sets the data rate maximum to MCS6.
tx data rate maximum mcs7
Sets the data rate maximum to MCS7.
tx power maximum <dBm>
Sets the TX power maximum in dBm.
<dBm> = measure of power in decibels with respect to one
milliwatt.
write
Stores the current configuration in permanent memory.
arp (config-arp) level commands
add <IP address> <MAC address>
Adds an entry to the ARP table, mapping an IP address to a MAC
address.
<ip address> = IP address to be mapped.
<mac address> = MAC address in colon-separated form.
clrscrn
Clears the screen.
exit
Exits to the configuration level.
remove all
Removes all entries from the ARP cache.
remove ip <IP address>
Removes an entry from the ARP cache.
<ip address> = address of the entry being removed.
show cache
Displays the ARP cache table.
show history
Displays the last 20 commands entered during the current CLI
session.
write
Stores the current configuration in permanent memory.
bridge 1 (config-bridge:br0) level commands
bridging mac address <hexadecimal>
Sets the Bridging MAC Address.
Each byte is represented by two adjacent hex digits.
Bytes may run together or be separated by optional punctuation:
123ABC "12 3A BC" 12,3A,BC 12.3a.bc 12:3a:bc
Note that quotes must enclose the value if it contains spaces.
clrscrn
Clears the screen.
exit
Exits to the config level.
no bridging mac address
Removes the Bridging MAC Address.
show
Displays the current configuration.
show history
Displays the last 20 commands entered during the current CLI
session.
show statistics
Show bridge statistics
show status
Show bridge status
state disable
Disables bridging.
state enable
Enables bridging.
write
Stores the current configuration in permanent memory.
choice 1 (config-wlan-choice:wlan0:1) level commands
apply wlan
Try out WLAN settings without saving them to Flash.
If the settings do not work, when you reboot the device,
it will still have the original settings.
clrscrn
Clears the screen.
exit
Exits to the next higher level.
PremierWave EN Command Reference 57