Integration Guide

MatchPort b/g Pro Integration Guide 3
Disclaimer and Revisions
Operation of this equipment in a residential area is likely to cause interference to other
devices, in which case the user, at his or her own expense, will be required to take
whatever measures may be required to correct the interference.
Note: This product has been designed to comply with the limits for a Class B
digital device pursuant to Part 15 of FCC and EN55022:1998 Rules when
properly enclosed and grounded. These limits are designed to provide
reasonable protection against radio interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy, and if not
installed and used in accordance with this guide, may cause interference to radio
communications.
Changes or modifications to this device not explicitly approved by Lantronix will void the
user's authority to operate this device.
Note: With the purchase of MatchPort b/g Pro, the OEM agrees to an OEM
firmware license agreement that grants the OEM a non-exclusive, royalty-free
firmware license to use and distribute the binary firmware image provided, only to
the extent necessary to use the MatchPort b/g Pro hardware. For further details,
please see the MatchPort b/g Pro OEM firmware license agreement.
Disclaimer
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
u Reorient or relocate the receiving antenna.
u Increase the separation between the equipment and receiver.
u Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
u Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This device is intended only for OEM Integrators. The OEM integrator should be aware of
the following important issues.
Labeling of the End Product
The label on the end product incorporating the MatchPort b/g pro module must clearly
state that it contains an FCC-approved RF module. For example: “This product contains
an RF transmitter FCC ID: R68MPBGPRO and IC: 3867A-MPBGPRO.”