Integration Guide

MatchPort b/g Pro Integration Guide 4
RSS-GEN Sections 7.1.4 and 7.1.5 Statement for Devices with Detachable Antennas
This device has been designed to operate with the antennas listed in the Certificate, and
having a maximum gain of 5 dBi. Antennas not included in this list or having a gain
greater than 5 dBi are strictly prohibited for use with this device, unless system-level FCC
approval is gained. The required antenna impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (EIRP) is not more
than that required for successful communication.
Integration Note
a) This module is authorized under limited module approval specified to mobile host
equipment. So, the antenna must be installed such that 20cm is maintained between the
antenna and users.
b) The transmitter module may not be co-located with any other transmitter or antenna.
As long as the two conditions above are met, further transmitter testing will not be
required. However, the OEM integrator is still responsible for testing their end product for
any additional compliance requirements required with this module installed (for example,
digital device emission, PC peripheral requirements, etc.)
Note: In the event that these conditions cannot be met (for example certain
laptop configurations, general purpose PCMCIA or similar cards, or co-location
with another transmitter), then the FCC authorization is no longer considered
valid and the FCC ID cannot be used on the final product (including the
transmitter) and obtaining a separate FCC authorization.
Note: Changes or modifications to this device not explicitly approved by Lantronix will
void the user's authority to operate this device.
Date
Rev.
Comments
??? A Initial Release