user manual

6: Network Settings
PremierWave XC User Guide 38
To Configure Network 1 Link Settings
Using Web Manager
 To modify Ethernet (eth0) Link information, click Network on the menu and select Network 1
-> Link.
Using the CLI
 To enter the eth0 Link command level: enable -> config -> if 1 -> link
Using XML
 Include in your file: <configgroup name="ethernet" instance="eth0">
Network 2 Interface Status
To View Network 2 Interface Status
On the Network 2 Interface Status page, you can view the GSM/GPRS status of the device.
 To view the Network 2 (wwan0) Status page, click Network on the menu bar and select
Network 2 -> Status.
Network 2 SMS Outbound Settings
The table below shows the settings for SMS Outbound messages and to send a test message.
Table 6-5 Network 2 (wwan0) SMS Outbound Settings
Network 2 (wwan0)
SMS Outbound Settings
Description
SMS Outbound
Select the appropriate SMS format.
Note:

Select the Text ASCII when sending SMS in Text format
(7 bit characters and typically limited to 160 characters per message.)
 Select Binary to send SMS in Binary format.
(8 bit characters and typically limited to 140 characters per message.)
 Select Unicode to send SMS in Unicode format.
(16 bit characters and typically limited to 70 characters per message.)
Message Center No.
Input the SMS center Number.
Note: This field is required only if the SMS center is incorrect.
Channel
Select the appropriate Channel to send SMS.
Note: The default network setting for transmission of SMS messaging is GSM.
However, there are carriers that support sending of SMS messages over their
GPRS network. Check with your provider.