User Guide

Open-Q 660 uSOM Wi-Fi/BT Certification OEM Integrator Guide
13
9 Required Labeling on the Outside of the Host
9.1 FCC Labeling Requirements on the Outside of the Host
The FCC requires a label on the outside of the host system visible to the end user.
Example wording is:
Contains:
FCC ID: R68OQ660US
IC: 3867A-OQ660US
The FCC requires a logo signifying emission compliance on the outside of the host system. The OEM
integrator is responsible to perform FCC Part 15 Class B digital emissions testing on the end system with
the radio Module installed. The FCC logo below should not be affixed unless the OEM integrator has
obtained the necessary Part 15 approval, e.g., self-declaration of conformity.
If the host system is approved to FCC Class B digital emissions limits under a grant of certification issued
by a TCB, the FCC ID number shown on the grant should be used on the label instead of the FCC logo
shown in Figure 1 below.
Figure 1. FCC Logo
Also see https://www.fcc.gov/logos.
A certified module has the option to use a permanently affixed label, or an electronic label (Refer to FCC
KDB 784748 D02 for e-labelling guidance). All modules without an integrated display on the module must
be labelled with a module’s FCC ID - Section 2.926.
9.2 Industry Canada Labeling Requirements on the Outside of the
Host
End Product Labeling
The final end product must be labeled in a visible area with the following for the Open-Q 660 uSOM:
Contains IC: 3867A-OQ660US.
Plaque signalétique du produit final
Le produit final doit être étiqueté dans un endroit visible avec l'inscription suivante pour l'Open-Q 660
uSOM:
Contient des IC: 3867A-OQ660US.