User's Manual

PW2050 Embedded Device Server Integration Guide 16
Antenna Type Peak Gain Typical Lantronix
Part
Number
Vendor Vendor
Part
Number
Approved
Region
Mexico
Table 2-4 PW2050 Wi-Fi External Antenna Options via On Module U.FL
Antenna Type Peak Gain Typical Lantronix
Part
Number
Vendor Vendor
Part
Number
Approved
Region
PCB Strip Antenna with
50mm cable to U.FL
connector
With tape backing
2.5dBi, 2.39 Ghz to 2.49 Ghz
5dBi, 4.9Ghz to 5.9Ghz
XPW100A
003-01-B
50 piece
bulk pack
Ethertronics
®
1001077 FCC, IC,
EU,
AUS/NZS,
JPN, China,
Mexico
PCB Strip Antenna with
50mm cable to U.FL
connector
Without tape backing
2.5dBi, 2.39 Ghz to 2.49 Ghz
5dBi, 4.9Ghz to 5.9Ghz
Ethertronics 1000668 FCC, IC,
EU,
AUS/NZS,
JPN, China,
Mexico
Swivel type antenna,
with RP-SMA(M)
connector
2 dBi, 2.4 Ghz to 2.5 Ghz, 2 dBi,
5.15 Ghz to 5.85 Ghz
930-033-R-
ACC
50 piece
bulk pack
Wanshih WSS002 FCC, IC,
EU,
AUS/NZS,
JPN, China,
Mexico
Swivel type antenna,
with RP-SMA(M)
connector
3.8 dBi, 2.4Ghz to 2.5Ghz,
5.5 dBi, 4.9 Ghz to 5.8Ghz
Taoglas GW.71.5153
(Not for EU
use)
FCC, IC,
AUS/NZS,
JPN, China,
Mexico
Note: The PCB strip antenna is available from Ethertronics with or without adhesive tape
backing for mounting to a plastic case. The antennas Lantronix supplies include an
adhesive backing. For the component without tape backing a non-conductive double
sided adhesive tape can be used to fix the antenna in place. The Ethertronics part
numbers listed above come with a 50mm U.FL cable attached to the PCB strip antenna.
The 50mm cable length is the minimum allowed cable length for use with the PW2050
Wi-Fi embedded device server. For similar PCB strip antennas with longer cables
consult with Ethertronics (www.ethertronics.com
).
Note: In order to use the on module U.FL connector signal RF1_CTL
(pin 97) should be pulled high or left floating.
Lantronix provides a U.FL to Reverse SMA antenna cable in with the evaluation board and
sample kits for development work. These cables can be purchased from Lantronix for
production or supplied by an RF cable manufacturer. External antennas can be purchased
from an antenna vendor. Components for cable design should be selected for low loss over
the entire 2.4Ghz to 5.9Ghz signal range. The cable target impedance should be 50 ohms.
Figure 錯誤! 使用 [常用] 索引標籤將 Heading 1 套用到您想要在此處顯示的文字。-3 Reverse-SMA to U.FL
(Long) (Lantronix Part Number 500-180-R-ACC)