User Guide

Bottom Panel
On the PremierWave XC Bottom panel, there is the SIM cover for the SIM card as shown in
Figure 3-9.
Figure 3-9 PremierWave XC bottom View
Installing The PremierWave XC
Be sure to place or mount the device securely on a flat horizontal or vertical surface. The device
comes with mounting brackets for mounting the device vertically, for example on a wall. If using
AC power, avoid outlets controlled by a wall switch.
Observe the following guidelines when connecting the serial devices:
 The PremierWave XC serial ports support RS-232/422/485
 The null modem cable is the best cable to connect the serial port to another DTE device. The
straight-though (modem) cable is the best cable to connect the serial port to a DCE device.
 Connect your RJ-45 Ethernet cable to the RJ-45 port of the unit.
 The device supports a power range of 9 to 30 VDC. You can power up the device with barrel-
power connector and/or the 3 pin Terminal connector for backup power supply.
Note: As soon as you plug the device into power, the device powers up automatically,
the self-test begins, and LEDs would indicate the device's status
Perform the following steps to install your device which are numbered in Figure 3-10 also.
1. Connect serial devices to the serial port of the unit.
PremierWave XC User Guide 23