User Guide

Table 7-7 Tunnel Disconnect Mode Settings
Tunnel Disconnect Mode
Settings
Description
Stop Character Enter the Stop Character which when received on the Serial Line, disconnects
the tunnel. The Stop Character may be designated as a single printable
character or as a control character. Control characters may be input in any of
the following forms: <control>J or 0xA(hexadercimal) or \10 (decimal).
Disable the Stop Character by blanking the field to set it to <None>.
Modem Control Set whether Modem Control enables disconnect when the Modem Control pin
is not asserted on the Serial Line. Choices are:
 Enabled
 Disabled (default)
Timeout Enter the number of milliseconds a tunnel may be idle before disconnection.
The value of zero disables the idle timeout.
Flush Serial Data Set whether to flush the Serial Line when the Tunnel is disconnected. Choices
are:
 Enabled
 Disabled (default)
To Configure Tunnel Disconnect Mode Settings
Using Web Manager
 To configure the Disconnect Mode for a specific tunnel, click Tunnel in the menu bar and
select Tunnel 1 -> Disconnect Mode.
Using the CLI
 To enter the Tunnel 1 Disconnect command level: enable -> tunnel 1 ->
disconnect
Using XML
 Include in your file: <configgroup name=”tunnel disconnect” instance=”1”>
Modem Emulation
Some older equipment is designed to attach to a serial port and dial into a network with a modem.
This equipment uses AT commands to control the connection. For compatibility with these older
devices on modern networks, our product mimics the behavior of the modem.
Table 7-8 Tunnel Modem Emulation Settings
Tunnel Modem Emulation
Settings
Description
PremierWave XC User Guide 54