User's Manual

8: Action Settings
PremierWave XC HSPA+ User Guide 43
To Configure Action Settings
Using Web Manager
 To modify Action information, click Action on the menu and select a specific action from the
drop-down menu. Alarms and Reports (on page 42) lists the options.
Using the CLI
 To enter the link command level: enable -> config -> action -> eth0 link state
change
 To enter the link command level: enable -> config -> action -> wwan0 link
state change
Using XML
 Include in your file: <configgroup name = "action" instance = "eth0 link
state change">
 Include in your file: <configgroup name = "action" instance = "wwan0 link
state change">
HTTP Post Use HTTP Post post to configured HTTP server. The URL appears behind the HTTP
server IP address or hostname. E.g. http://some_http_server/some_url The IP
Address or hostname is the HTTP server to connect to. Port number is the port which
HTTP server is listening on. Use Protocol to connect to HTTP server. HTTPS is a
SSL encrypted communication channel and SSL Trusted Authorities must be setup
withHTTP server SSL certificate. Username used to logon to HTTP server if
authentication is required. Password used to logon to HTTP server if authentication
is required. If the alarm stays on or off longer than the Reminder Interval, another
HTTP Post is performed. In Sequential mode, connections will be attempted starting
with number 1 until a connection is successful. In Simultaneous mode, all possible
connections will be made.
Relay Select a Relay to switch on when this alarm is activated. Select “None” so this alarm
state will have no effect on any Relay.
GPRS Roaming Select GPRS Roaming to enable or disable GPRS roaming when this alarm is on.
Select No Change so this alarm state will have no effect on GPRS roaming.
SMS Use SMS to send SMS to configured Recipient. The contents of Alarm Message will
be placed into the SMS body when an alarm SMS is sent. If the alarm stays on
longer than the Reminder Interval, another alarm SMS is sent. The contents of
Normal Message will be placed into the SMS body when a normal SMS is sent. If the
alarm stays off longer than the Reminder Interval, another normal SMS is sent.
SNMP Trap Use SNMP Trap to send SNMP trap to configured trap destinations. The contents of
Alarm Message are included when an alarm SNMP trap is sent. If the alarm stays on
longer than the Reminder Interval, another alarm SNMP Trap is sent. The contents of
Normal Message are included when a normal SNMP trap is sent. If the alarm stays
off longer than the Reminder Interval, another normal SNMP Trap is sent.
Action Settings Description
PRELIMINARY DRAFT
PRELIMINARY DRAFT