User's Manual

9: Line and Tunnel Settings
PremierWave XC HSPA+ User Guide 49
To Configure Tunnel Packing Mode Settings
Using Web Manager
 To configure the Packing Mode for a specific tunnel, click Tunnel in the menu and select
Tunnel 1 -> Packing Mode.
Using the CLI
 To enter the Tunnel 1 Packing command level: enable -> tunnel 1 -> packing
Using XML
 Include in your file: <configgroup name="tunnel packing" instance="1">
Accept Mode
In Accept Mode, thePremierWave listens (waits) for incoming connections from the network. A
remote node on the network initiates the connection.
The configurable local port is the port the remote device connects to for this connection.
Table 9-5 Tunnel Accept Mode Settings
Timeout Set the timeout value, in milliseconds, after the first character is received on
the serial line, before data is sent on the network. Valid range is 1 to 30000
milliseconds. Default is 1000.
Send Character Enter Control Characters in any of the following forms:
 <control>J
 0xA (hexadecimal)
 \10 (decimal)
If used, the Send Character is a single printable character or a control
character that, when read on the Serial Line, forces the queued data to be
sent on the network immediately.
Trailing Character Enter Control Characters in any of the following forms:
 <control>J
 0xA (hexadecimal)
 \10 (decimal).
If used, the Trailing Character is a single printable character or a control
character that is injected into the outgoing data stream right after the Send
Character. Disable the Trailing Character by blanking the field (setting it to
<None>).
Tunnel Accept Mode
Settings
Description
Mode Set the method used to start a tunnel in Accept mode. Choices are:
 Disable = do not accept an incoming connection.
 Always = accept an incoming connection (default).
Tunnel Packing Mode
Settings (continued)
Description
PRELIMINARY DRAFT
PRELIMINARY DRAFT