User's Manual

10: Terminal and Host Settings
PremierWave XC HSPA+ User Guide 58
Host Configuration
Table 10-2 Host Configuration
To Configure Host Settings
Note: The following section describes the steps to view and configure Host 1 settings;
these steps apply to other host instances of the device.
Using Web Manager
 To configure a particular Host, click Host on the menu and select Host 1 -> Configuration.
Using the CLI
 To enter the Host command level: enable -> config -> host 1
Using XML
 Include in your file: <configgroup name=”host” instance=”1”>
Host Settings Description
Name Enter a name for the host. This name appears on the Login Connect
Menu. To leave a host out of the menu, leave this field blank.
Protocol Select the protocol to use to connect to the host. Choices are:
 Telnet
 SSH
Note: SSH keys must be loaded or created on the SSH page for the
SSH protocol to work.
SSH Username Appears if you selected SSH as the protocol. Enter a username to
select a pre-configured Username/Password/Key (configured on the
SSH: Client Users page), or leave it blank to be prompted for a
username and password at connect time.
Remote Address Enter an IP address for the host to which the device will connect.
Remote Port Enter the port on the host to which the device will connect.
PRELIMINARY DRAFT
PRELIMINARY DRAFT