User's Manual

11: Services Settings
PremierWave XC HSPA+ User Guide 60
To Configure FTP Settings
Using Web Manager
 To configure FTP, click FTP in the menu.
Using the CLI
 To enter the FTP command level: enable -> config -> ftp
Using XML
 Include in your file: <configgroup name=”ftp server”>
Syslog Settings
The Syslog information shows the current configuration and statistics of the syslog. Here you can
configure the syslog host and the severity of the events to log.
Note: The system log is always saved to local storage, but it is not retained through
reboots unless diagnostics logging to the filesystem is enabled. Saving the system log to a
server that supports remote logging services (see RFC 3164) allows the administrator to
save the complete system log history. The default port is 514.
Table 11-3 Syslog Settings
To View or Configure Syslog Settings:
Using Web Manager
 To configure the Syslog, click Syslog in the menu.
Using the CLI
 To enter the Syslog command level: enable -> config -> syslog
Syslog Settings Description
State Select to enable or disable the syslog:
 Enabled
 Disabled (default)
Host Enter the IP address of the remote server to which system logs are sent for storage.
Remote Port Enter the number of the port on the remote server that supports logging services.
The default is 514.
Severity Log Level Specify the minimum level of system message the PremierWave should log. This
setting applies to all syslog facilities. The drop-down list in the Web Manager is in
descending order of severity (e.g., Emergency is more severe than Alert.)
PRELIMINARY DRAFT
PRELIMINARY DRAFT