User's Manual
Table Of Contents
- PremierWave XC HSPA+ User Guide
- 1: Using This Guide
- 2: Introduction
- 3: Installation of PremierWave XC HSPA+
- 4: Using DeviceInstaller
- 5: Configuration Using Web Manager
- 6: Network Settings
- Network 1 (eth0) Interface Settings
- Network 1 (Link) Settings
- Network 1 (Failover)
- Network 2 (Cellular) Settings
- Network 2 (Link) Settings
- Gateway
- 7: Cellular
- 8: Action Settings
- 9: Line and Tunnel Settings
- Line Settings
- Tunnel Settings
- Serial Settings
- To Configure Tunnel Serial Settings
- Packing Mode
- To Configure Tunnel Packing Mode Settings
- Accept Mode
- To Configure Tunnel Accept Mode Settings
- Connect Mode
- To Configure Tunnel Connect Mode Settings
- Disconnect Mode
- To Configure Tunnel Disconnect Mode Settings
- Modem Emulation
- To Configure Tunnel Modem Emulation Settings
- Relay Output
- 10: Terminal and Host Settings
- 11: Services Settings
- 12: Security Settings
- 13: Maintenance and Diagnostics Settings
- Filesystem Settings
- Protocol Stack Settings
- SMTP Settings
- Diagnostics
- Threads
- Clock
- System Settings
- Discovery and Query Port
- 14: Advanced Settings
- 15: Security in Detail
- 16: Updating Firmware
- 17: Branding the PremierWave XC HSPA+
- Appendix A: Technical Specifications
- Appendix B: Compliance
- Appendix C: Technical Support
- Appendix D: Binary to Hexadecimal Conversions
- Appendix E: USB-CDC-ACM Device Driver File for Windows Hosts
11: Services Settings
PremierWave XC HSPA+ User Guide 64
SNMP Settings
Simple Network management Protocol (SNMP) settings may be viewed and configured in this
section.
Table 11-7 SNMP Settings
To Configure SNMP Settings
Using Web Manager
To configure SNMP, click SNMP in the menu.
Using the CLI
To enter the SNMP command level: enable -> config -> snmp
Using XML
Include in your file: <configgroup name=”snmp”>
SMS
Allows the user to view and configure inbound/outbound SMS to/from the device.
Inbound SMS
Table 11-8 Inbound SMS Settings
RSS Settings Description
System Location Specify a system location for the SNMP setting.
Primary Destination Specify SNMP trap primary destination.
Secondary
Destination
Specify SNMP trap secondary destination.
Community Specify SNMP trap community.
Inbound SMS Settings Description
Delete Click beside an existing SMS Sender Configuration to delete it.
Number Enter the sender number of a new SMS Sender to add.
Shoulder Tap Check to allow incoming SMS with content containing ‘shoulder tap’ from this
sender to start the cellular interface.
Relay Control Check to allow incoming SMS with content containing ‘relay N On/Off’ from this
sender to open and close the device relays.
PRELIMINARY DRAFT
PRELIMINARY DRAFT