User Manual

Command Reference Modem Commands
12-99
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
DisableString
A string of up to 12 characters. When the modem receives this string,
automatic answering will be disabled.
EnableString
A string of up to 12 characters. When this string is received by the modem,
error correction will be enabled.
Note: The DisableString and the EnableString must be entered together.
Defaults Disabled (no strings defined)
Examples
Local>> DEFINE PORT 2 MODEM ERRORCORRECTION ENABLED
Local>> DEFINE PORT 2 MODEM ERRORCORRECTION “&q5” “q0”
See Also Profile Settings, page 9-5; Define Ports Modem Error, page 12-98
12.7.13 Define Ports Modem Getsetup
Defines a string to send to the modem to cause it to return its setup. This string is preceded by the
Commandprefix string. If the string is set to “”, the SCS will not attempt to get the modem’s setup. The SCS
will always send the Save string after configuration. Modems that do not return their configuration in a
single screen should do this.
Restrictions Requires privileged user status.
Parameters PortList/All
Specifies a particular port or group of ports, or all ports. Port numbers should
be separated with commas (for lists) or dashes (for ranges).
Note: In the absence of a PortList or the All parameter, the configuration will affect the
current port only.
string
A string of up to 12 characters. Commonly set to “&v.”
Defaults Depends on modem and modem profile.
Examples
Local>> DEFINE PORT 2 MODEM GETSETUP “&v”
DEFINE PORTS
PortList
ALL
MODEM GETSETUP string