User Manual

Basic Remote Networking Examples
4-21
This SCS must be configured for outgoing LAN to LAN connections.
Figure 4-32: Dallas SCS Configuration
The Initialize Server Delay 0 command will reboot the SCS; when the unit has rebooted, changes made
with the Define commands will be in effect.
This SCS must then be configured using the following commands:
Figure 4-33: Seattle SCS Configuration
4.8.2 LAN to LAN—Bidirectional (Symmetric) Calling
An SCS in a remote office in Dallas must be able to call an SCS at the company headquarters in Seattle.
This LAN to LAN connection must meet the following criteria:
◆ The SCS in Seattle must also be able to call Dallas.
◆ IP traffic must be transferred between Seattle and Dallas.
◆ IP users in Dallas must connect to IP network 192.0.1.0 in Seattle. IP users in Seattle must connect to
IP network 192.0.2.0 in Dallas.
Local>> DEFINE PORT 2 ACCESS DYNAMIC
Local>> DEFINE PORT 2 MODEM ENABLED
Local>> LIST MODEM
Local>> DEFINE PORT 2 MODEM TYPE 1
Local>> DEFINE PORT 2 MODEM SPEAKER DISABLED
Local>> DEFINE PORT 2 AUTHENTICATE ENABLED
Local>>
Local>> DEFINE SITE SEATTLE AUTHENTICATION USERNAME “dallas”
Local>> DEFINE SITE SEATTLE AUTHENTICATION REMOTE “xyz”
Local>> DEFINE SITE SEATTLE AUTHENTICATION CHAP ENABLED
Local>> DEFINE SITE SEATTLE IDLE 60
Local>> DEFINE SITE SEATTLE PORT 2
Local>> DEFINE SITE SEATTLE TELEPHONE [phone]
Local>>
Local>> DEFINE IP ROUTE 192.0.1.0 SITE SEATTLE 2
Local>>
Local>> INITIALIZE SERVER DELAY 0
Local>> DEFINE PORT 2 MODEM ENABLED
Local>> LIST MODEM
Local>> DEFINE PORT 2 MODEM TYPE 1
Local>> DEFINE PORT 2 MODEM SPEAKER DISABLED
Local>> DEFINE PORT 2 AUTHENTICATE ENABLED
Local>> DEFINE PORT 2 PPPDETECT ENABLED
Local>> DEFINE PORT 2 PPP CHAP REMOTE
Local>> DEFINE PORT 2 AUTHENTICATE ENABLED
Local>> LOGOUT PORT 2
Local>>
Local>> DEFINE SITE dallas AUTHENTICATION LOCAL “xyz”
Local>> DEFINE IP ROUTING ENABLED
Local>>
Local>> INITIALIZE SERVER DELAY 0