User's Manual
Table Of Contents
- Table of Contents
- OneTouch® DataLink® Connection Overview
- OneTouch® DataLink® Sync Configuration
- Modem-to-Modem Configuration
- Serial Server/Client-to-Ethernet Configuration
- Serial Server/Client-to-Ethernet Configuration Using Modems
- Terminal Server-to-Ethernet Configuration Using Multiple Receiving Modems
- Connecting to the Workstation
- Wireless Communication
- Establishing Connectivity Using OneTouch® MeterLink™ Software
- Transferring Data
- Troubleshooting
- Specifications
- Glossary
- Index
15
Connecting a Receiving Modem to the Workstation
Follow this procedure to connect a receiving modem to the workstation (see Figure 8).
1 Set the switches on the back of the modem as follows:
2 Connect the power cord from the modem to an AC power outlet.
3 Connect a phone cable from the modem to an analog phone jack. The phone
jack must be for a dedicated analog phone line.
■ NOTE: The modem’s jack is labeled with a wall plug icon on the bottom of the modem.
4 Connect the serial modem cable from the modem to the serial port on the
workstation.
5 If applicable, connect the network patch cable from the workstation to the
network jack.
6 Turn on the modem and workstation.
Figure 8 Modem-to-workstation connection
12345678
down up up down up up down up
ethernet.book Page 15 Tuesday, December 11, 2007 11:25 AM