User's Manual

23
Replacing the Wireless Unit Battery
This procedure applies only to version 2 of the wireless units. After replacing the battery,
you must charge it.
▲ CAUTION: Use only the Lantronix NiMH (#510-005) battery pack (order from
LifeScan, part number 02172001A). Using any other battery pack will
void the warranty and can damage the wireless unit.
LifeScan recommends recycling NiMH batteries. Contact your local Rechargeable Battery
Recycling Corporation (RBRC) or visit www.rbrc.org for information.
1 Turn the unit over and remove the two screws on the battery door.
2 Lift up on the door to remove it.
3 Disconnect the battery’s 5-pin connector plugged into the wireless unit. If
necessary, use a small, flat-head screwdriver to pry up on the edge of the
connector. Remove the battery.
Figure 11 Battery pack in version 2 of wireless unit
4 Install the new battery by first plugging in the connector (it fits in one
orientation only), then placing the battery, label up, in the compartment. Tuck
in the battery wires in the space above the battery to the left of the connector
(see Figure 11).
5 Replace the battery door by aligning the screw holes. Avoid pinching the wires.
6 Replace the screws.
7 Follow the instructions for charging the battery.
LANTRONIX
510-005
3-6V 2500mAH
NiMH
5-pin connector
ethernet.book Page 23 Tuesday, December 11, 2007 11:25 AM