User's Manual

33
Messages appear on the screen indicating the
status of the transfer. The meter beeps and a
message appears when data transfer is
complete.
2 Remove the meter from the connection module cradle and press Cont.
If the meter is off when you remove it from the connection module, you can verify that
the transfer was successful by turning on the meter. If an error occurred during the
transfer, the following message appears after the status screen: Last Data Transfer mm/
dd/yy hh:mm Failed. Additionally, the status of the last upload appears at the status
screen.
Using a Serial Cable
A serial cable may be used to transfer data between the meter and the workstation. Use the
built-in serial cable in the cradle to connect to a PC server, serial server/client, modem, or
the workstation’s serial port. Or, use the OneTouch
®
DataLink
®
serial cable for a direct
connection to the workstation.
1 Connect the serial cable (either the
OneTouch
®
DataLink
®
serial
cable or the cable in the cradle) to
the meter.
Messages appear on the screen
indicating the status of the transfer.
The meter beeps and a message
appears when data transfer is
complete.
serial cable in cradle
serial cable
ethernet.book Page 33 Tuesday, December 11, 2007 11:25 AM