User's Manual

Configuration Using DeviceInstaller
WiBox™ User Guide 19
d) Authentication: when WEP is set to enabled, select an authentication
scheme.
Authentication 0=open/none, 1=shared (0) ?_
e) Encryption: when WEP is set to enabled, select the encryption type from the
menu.
Encryption 0=WEP64, 1=WEP128 (0) ?_
f) Change Key: displays when WEP is enabled. Select Y to change the
encryption key. Enter the key at the prompt.
Change Key (N) ? _
g) Data Rate: the data rate is the WiBox’s bandwidth.
Data rate, Only : 0=1, 1=2, 2=5.5, 3=11 Mbps or
Up to: 4=2, 5=5.5, 6=11 Mbps (6) ?
h) Power Management: enter Y to reduce the WiBox’s overall power
consumption (this increases the unit’s response time).
Enable power management (N) ? _
8. Upon completing the IP and WLAN settings configuration, select menu option 9
to save and exit the Wibox Serial Mode setup.
9. The WiBox is ready for wireless connection. Disconnect the serial cable from the
PC or to the WiBox.