User's Manual

Configuration via Serial Mode or Telnet Port
34 WiBox™ User Guide
Select between two different packing algorithms (the current configuration is
displayed within the parentheses). Available Flush Mode options are:
Table 4-11. Flush Mode Options
Function 7 6 5 4 3 2 1 0
Input Buffer (Serial to Network)
Clear with a connection that is initiated from the
device to the network
1
Clear with a connection initiated from the network
to the device
1
Clear when the network connection to or from the
device is disconnected
1
Output Buffer (Network to Serial)
Clear with a connection that is initiated from the
device to the network
1
Clear with a connection initiated from the network
to the device
1
Clear when the network connection to or from the
device is disconnected
1
Alternate Packing Algorithm (Pack Control)
Enable 1
Pack Control
The packing algorithm defines how and when packets are sent to the network. The
standard algorithm is optimized for applications in which the unit is used in a local
environment. The alternate packing algorithm minimizes the packet count on the
network and is especially useful in applications in a routed Wide Area Network
(WAN). Adjusting parameters in this mode can economize the network data stream.
Pack control settings are enabled in Flush Mode. Set this value to 00 if specific
functions are not needed.
Table 4-12. Pack Control Options
Option 7 6 5 4 3 2 1 0
Packing Interval
Interval: 12ms 0 0
Interval: 52ms 0 1
Interval: 250ms 1 0
Interval: 5sec 1 1
Trailing Characters
None 0 0
One 0 1