User's Manual

Configuration via Serial Mode or Telnet Port
WiBox™ User Guide 39
Disable TFTP Firmware Update (N) : _
With this option, download firmware upgrades over the serial port using
DeviceInstaller’s Recover Firmware procedure (see Recovering the Firmware Using
the Serial Port on page 12).
Disable Port 77FE (Hex)
Note: Disabling both Telnet Setup and Port 77FE prevents users from
accessing the setup menu from the network.
Port 77FE is used by DeviceInstaller, Web-Manager, and custom programs to
configure the unit remotely. If required, disable this capability for security purposes.
Disable Port 77FEh (N) ? _
The default setting is the N (No) option, which enables remote configuration. As a
result, configure the unit by using DeviceInstaller, web pages, Telnet, or serial
configuration.
The Y (Yes) option disables remote configuration and web sites.
Note: The Y (Yes) option disables many of the GUI tools for configuring the
unit, including the embedded Web-Manager tool.
Disable Web Server
The Y (Yes) option disables the web server. This setting defaults to the N (option).
Disable Web Server (N) ? _
Disable Web Setup
The Y (Yes) option disables configuration via the Web-Manager. This setting defaults
to the N (option).
Disable Web Setup (N) ? _
Disable ECHO Ports
This setting controls whether the serial port echoes characters it receives. The
current value is displayed in parentheses.
Disable ECHO ports (Y) ? _
Enable Enhanced Password
This setting defaults to the N (option), which permits a 4-character password
protecting Setup Mode by means of Telnet and web pages.
Enable Enhanced Password (Y) ? _
The Y (Yes) option allows an extended security password of 16-characters for
protecting Telnet access.
Factory Defaults
Select 7 Factory Defaults from the Change Setup menu to reset the unit’s Channel
1 configuration, Channel 2 configuration, E-mail settings, and Expert settings to the
factory default settings. The server configuration settings for IP address, gateway IP