Data Sheet

xPico
®
200 Series Embedded Wi-Fi
®
Gateway Data Sheet 30
7: Antenna Connection Options
The xPico 200 module supports wireless connectivity via two U.FL connectors for single
stream transmit and receive diversity.
An on-module stamped metal antenna version is also available as a product SKU option. The
single antenna is used for transmit and receive. Diversity is not available on the module with
the on-module antenna.
The xPico 200 modules are certified using the antennas listed in Table 7-1 and Table 7-2
below.
Refer to the compliance section below for certification requirements related to antenna selection.
Table 7-1: External Antenna Options
Antenna Type Peak Gain
Typical
Lantronix
Part
Number
Vendor Vendor Part
Number
Approved
Region
PCB strip antenna
with 50 mm cable to
U.FL connector
With tape backing
2.5 dBi, 2.39 Ghz
to 2.49 Ghz
5dBi, 4.9Ghz to
5.9Ghz
XPW100A
003-01-B
50 piece
bulk pack
Ethertronics 1001077 FCC, IC,
EU,
AUS/NZS,
JPN, China,
Mexico
PCB strip antenna
with 50 mm cable to
U.FL connector
Without tape
backing
2.5 dBi, 2.39 Ghz
to 2.49 Ghz
5dBi, 4.9Ghz to
5.9Ghz
Ethertronics 1000668 FCC, IC,
EU,
AUS/NZS,
JPN, China,
Mexico
Swivel type
antenna, with RP-
SMA(M) connector
2 dBi, 2.4 Ghz to
2.5 Ghz, 2 dBi,
5.15 Ghz to 5.85
Ghz
930-033-R-
ACC
50 piece
bulk pack
Wanshih WSS002 FCC, IC,
EU,
AUS/NZS,
JPN, China,
Mexico
Swivel type
antenna, with RP-
SMA(M) connector
3.8 dBi, 2.4Ghz to
2.5Ghz,
5.5 dBi, 4.9 Ghz
to 5.8Ghz
Taoglas GW.71.5153
(Not for EU
use)
FCC, IC,
AUS/NZS,
JPN, China,
Mexico
Note: Antenna gain listed above excludes cable loss.
Table 7-2: On-Module Antenna Option
Antenna Type Peak Gain Typical
On module stamped metal antenna 0 dBi 2.4 Ghz, 4 dBi 5 Ghz