User's Manual

Installation
Xerox
®
Wireless Print Solutions Adapter
User Guide
15
Status LED
The Status LED indicates various system status based on its color and blink pattern. The Status LED is
located on the top, front corner of the Wireless Print Solutions Adapter. For details, see
Parts of the Wireless
Print Solutions Adapter
on page 14.
Reset Button
To reset the device settings to factory default, you can use the Reset Button. Settings, including the IP
address, gateway, and network mask are set to 00.
To reset the device to factory defaults:
1. To depress the Reset Button, place the end of a paper clip or similar object into the Reset Button
opening. For details, see
Parts of the Wireless Print Solutions Adapter on page 14.
2. Continue to depress the Reset Button for 15 seconds, then remove the paper clip.
The adapter reboots automatically and restores to the factory-default settings.
Wi-Fi Protected Setup (WPS)
Using WPS, you can connect to the Wireless Print Solutions Adapter using a router or an access point in one
operation. This process is simpler than creating a profile with a network name (SSID), setting up wireless
security parameters, and updating the choice list.
Condition Green LED Flash Pattern
Adapter is powered on with no error conditions Continuous solid green light
Adapter is powered off LED is not illuminated
Locate Device function is in process Slow-flashing light occurs for two minutes. For details see
To
Configure System Settings
on page 41.
WPS button is pressed on adapter A slow-flashing light
Condition Amber LED Flash Pattern
No Ethernet Link is available Two long flashes followed by two short flashes that repeat.
No IP Address is obtained from the Ethernet
network
Two long flashes followed by three short flashes that
repeat.
No WLAN Link is available Three long flashes followed by two short flashes that
repeat.
No IP address is obtained from the WLAN
network
Three long flashes followed by three short flashes that
repeat.
WPS Profile Error One long flash followed by one short flash that repeats.
WPS Timeout Error One long flash followed by two short flashes that repeat.