User's Manual

Network Page
Xerox
®
Wireless Print Solutions Adapter
User Guide
26
For Keys 1-4, enter one or more encryption keys in hexadecimal format. Enter 10 hexadecimal
digits (0-9, a-f) for WEP40 and 26 for WEP104. For security reasons, the configured keys are not
shown.
Note: For maximum security, Xerox recommends that you use a passphrase of 20 or more characters.
Spaces and special characters are allowed.
4. Click Apply.
5. To test the settings, click Test Conne ction.
6. When you finish your selections, click Submit.
To Configure WPA or WPA2 Settings
WPA and WPA2/IEEE802.11i security suites are available for Infrastructure mode only.
WPA is a security standard specified by Wi-Fi Alliance Corporation. WPA2 is a Wi-Fi standard to enforce
better interoperability. The Wireless Print Solutions Adapter is compliant with both WPA and WPA2.
The WPA2 mode is compliant with the Robust Secure Network specified in the IEEE standard 802.11i.
1. For Suite, select WPA or WPA2/IEEE 802.11i
2. For Authentication, select an option.
– PSK, for Passphrase, type the key. For a Pre-shared key, ensure that the same key is configured
both on the Wireless Print Solutions Adapter side and on the Access Point side.
– IEEE 802.1X: This authentication method communicates with an authentication server that is
part of the network. The authentication server matches the credentials sent by the Wireless Print
Solutions Adapter with an internal database.
Note: For maximum security, Xerox recommends that you use a passphrase of 20 or more characters.
Spaces and punctuation characters are allowed.
3. For Key type, select either Passphrase or Hex.
4. If you select IEEE 802.1X, select the protocol to use to authenticate the WLAN client.
• LEAP: Type a User Name and Password, then select an Encryption. Options are CCMP, TKIP,
or WEP. Click Apply.
• EAP-TLS: Type a Username, then select a value for Encryption. Options are CCMP, TKIP, or
WEP. This option validates the certificate received from the authentication server. To
validate against a certificate installed on the device, select Enabled. For Credentials, select
the credential to validate against. If the credential is not listed, type the name for the
credential, then click Apply.
• EAP-TTLS: For EAP-TTLS Option, select a security protocol. Options include EAP-MSCHAPV2,
MSCHAPV2, MSCHAP, CHAP, PAP, and EAP-MD5. Type a Username and Password, then
select an Encryption. Options are CCMP, TKIP, or WEP. Click Apply.
• PEAP: For PEAP Option, select a security protocol. Options include EAP-MSCHAPV2 and
EAP-MD5. Type a Username and Password, then select an Encryption. Options are CCMP,
TKIP, or WEP. Click Apply.
5. To test the settings, click Test Conne ction.
6. When you finish your selections, click Submit.