User's Manual
Table Of Contents
- Figures
- Tables
- Using This Guide
- Introduction
- Installation and Hardware
- XPress DR+W
- Using DeviceInstaller
- Configuration Using Web Manager
- Configuration Using Telnet or Serial Port (Setup Mode)
- Setup Mode: Server Configuration
- Setup Mode: Channel Configuration
- Channel 1 (Option 1) and Channel 2 (Option 2)
- Baudrate
- I/F (Interface) Mode
- Flow
- Port Number
- Connect Mode
- Send the Escape Sequence (+++) in Modem Mode
- Auto Increment Source Port
- Remote IP Address
- Remote Port
- DisConnMode
- Flush Mode (Buffer Flushing)
- Pack Control
- DisConnTime (Inactivity Timeout)
- Send Characters
- Telnet Terminal Type
- Channel (Port) Password
- WLAN Settings (XPress DR+W Only)
- Setup Mode: Advanced Settings
- Firmware Upgrades
- Monitor Mode
- Troubleshooting and Technical Support
- Technical Specifications
- Lantronix Cables and Adapters
- Alternative Methods of Assigning an IP Address
- Binary to Hexadecimal Conversions
- Compliance Information
- Warranty
Appendix A: Technical Specifications
XPress DR+ User Guide 104
Category Description
Com Port Redirector, Windows® 98/NT/2000/XP-based virtual com port software
LEDs TX/RX activity per serial
Link/Activity per Ethernet port
Power/System OK
Wireless
Isolation 8 KV direct contact, 15 KV air discharge, ESD protection on all serial ports (IEC 1000-4-2,
IEC 61000-4-2)
2 K VAC / 2.8K VDC galvanic isolation between power input port to Ethernet ports (except
chassis ground)
2 K VAC / 2.8K VDC galvanic isolation between power input port to serial ports
Transient Voltage protection and ESD with max non-repetitive surge current 800 A (8/20
us) (IEC 61000-4-2)
2 K VAC / 2.8K VDC galvanic isolation between Ethernet ports (except chassis ground)
2 K VAC / 2.8K VDC galvanic isolation between Ethernet ports to serial ports
40 A (5/50 ns) EFT protection (IEC 61000-4-4), 12 A (8/20 us) lightning protection (IEC
61000-4-5) on all Ethernet ports
Agency Approvals UL, CSA, FCC, CE, TUV, CTick, VCCI, FM Class 1, Div. 2
Table 13-3. XPress DR+W Wireless Specifications
Category IEEE 802.11b/g
Frequency Range 2.412 – 2.484 GHz
Output Power 14 +/- 1.0 dBm <= 12 Mbps
12 +/- 1.0 dBm > 12 Mbps
Antenna Connector 1
Data Rates 1*,2*,5.5*,11*,6,9,12,18*,24*,36*,48,54*
Mbps
Number of
Selectable
Subchannels**
US 1-11
CA 1-11
JP 1-14
FR 10-13
SP 10-11
OT 1-13 (OT=Others)
Modulation DSSS,DBPSK,DQPSK,CCK, OFDM,
16QAM, 64QAM
Radio
Antenna
Connector
1
Security WEP 64/128,WPA
Maximum Receive Level 10 dBm (with PER < 8%)
Receiver Sensitivity 72 dBm for 54 Mbps
87 dBm for 11 Mbps
89 dBm for 5.5 Mbps
90 dBm for 2.0 Mbps
92 dBm for 1.0 Mbps