User's Manual
Table Of Contents
- Figures
- Tables
- Using This Guide
- Introduction
- Installation and Hardware
- XPress DR+W
- Using DeviceInstaller
- Configuration Using Web Manager
- Configuration Using Telnet or Serial Port (Setup Mode)
- Setup Mode: Server Configuration
- Setup Mode: Channel Configuration
- Channel 1 (Option 1) and Channel 2 (Option 2)
- Baudrate
- I/F (Interface) Mode
- Flow
- Port Number
- Connect Mode
- Send the Escape Sequence (+++) in Modem Mode
- Auto Increment Source Port
- Remote IP Address
- Remote Port
- DisConnMode
- Flush Mode (Buffer Flushing)
- Pack Control
- DisConnTime (Inactivity Timeout)
- Send Characters
- Telnet Terminal Type
- Channel (Port) Password
- WLAN Settings (XPress DR+W Only)
- Setup Mode: Advanced Settings
- Firmware Upgrades
- Monitor Mode
- Troubleshooting and Technical Support
- Technical Specifications
- Lantronix Cables and Adapters
- Alternative Methods of Assigning an IP Address
- Binary to Hexadecimal Conversions
- Compliance Information
- Warranty
XPress DR+ User Guide 105
Appendix B: Lantronix Cables and Adapters
Lantronix P/N Description Applications
500-103 6’ RJ45-to DB9F Included with XPress DR+ for setup or device
connectivity.
Connects the RJ45 RS232 serial ports of XPress DR+ to
a DB9M DTE interface of a PC or serial device.
200.2062 Cable Ethernet CAT5; RJ45, 2 m (6.6 ft) Connects the XPress DR+ Ethernet ports to an Ethernet
switch/hub or is used for cascading from one XPress
DR+ to another.
Connects the XPress DR+ serial RJ45 RS232 ports to a
device using one of the adapters listed below.
200.2063 Cable Ethernet CAT5; RJ45, 5 m (16.4 ft) Connects the XPress DR+ Ethernet ports to an Ethernet
switch/hub or is used for cascading from one XPress
DR+ to another.
Connects the XPress DR+ serial RJ45 RS232 ports to a
device using one of the below listed adapters.
200.2064 Cable Ethernet CAT5; RJ45, 10 m (32.8 ft) Connects the XPress DR+ Ethernet ports to an Ethernet
switch/hub or is used for cascading from one XPress
DR+ to another.
Connects the XPress DR+ serial RJ45 RS232 ports to a
device using one of the adapters listed below.
200.2065 Cable Ethernet CAT5; RJ45, 15 m (49.2 ft) Connects the XPress DR+ Ethernet ports to an Ethernet
switch/hub or is used for cascading from one XPress
DR+ to another.
Connects the XPress DR+ serial RJ45 RS232 ports to a
device using one of the adapters listed below.
200.2066A Adapter RJ45-to-DB25M Allows a standard straight-pinned CAT5 cable to connect
the XPress DR+ RJ45 serial ports to the DB25F DCE
interface of a serial device.
200.2067A Adapter RJ45-to-DB25F Allows a standard straight-pinned CAT5 cable to connect
the XPress DR+ RJ45 serial ports to the DB25M DTE
interface of a serial device.
200.2069A Adapter RJ45-to-DB9M Allows a standard straight-pinned CAT5 cable to connect
the XPress DR+ RJ45 serial ports to the DB9F DCE
interface of a serial device.
200.2070A Adapter RJ45-to-DB9F Allows a standard straight-pinned CAT5 cable to connect
the XPress DR+ to the DB9M DTE interface of a PC or
serial device.