User's Manual
Table Of Contents
- Figures
- Tables
- Using This Guide
- Introduction
- Installation and Hardware
- XPress DR+W
- Using DeviceInstaller
- Configuration Using Web Manager
- Configuration Using Telnet or Serial Port (Setup Mode)
- Setup Mode: Server Configuration
- Setup Mode: Channel Configuration
- Channel 1 (Option 1) and Channel 2 (Option 2)
- Baudrate
- I/F (Interface) Mode
- Flow
- Port Number
- Connect Mode
- Send the Escape Sequence (+++) in Modem Mode
- Auto Increment Source Port
- Remote IP Address
- Remote Port
- DisConnMode
- Flush Mode (Buffer Flushing)
- Pack Control
- DisConnTime (Inactivity Timeout)
- Send Characters
- Telnet Terminal Type
- Channel (Port) Password
- WLAN Settings (XPress DR+W Only)
- Setup Mode: Advanced Settings
- Firmware Upgrades
- Monitor Mode
- Troubleshooting and Technical Support
- Technical Specifications
- Lantronix Cables and Adapters
- Alternative Methods of Assigning an IP Address
- Binary to Hexadecimal Conversions
- Compliance Information
- Warranty
Chapter 3: Installation and Hardware
XPress DR+ User Guide 26
Table 3-6. XPress DR+ LED Functions
LED Status Meaning
Off No data being transmitted from XPress DR+ Serial port - TXD LED (Yellow)
Blinking
Data being transmitted from XPress DR+
Off No data being received by XPress DR+ Serial port - RXD LED (Green)
Blinking
Data being received by XPress DR+
Off No Ethernet link established. Ethernet port - 10/100 Link (Green)
Steady On
Ethernet link established.
Off
No data activity
Ethernet port – Activity (Yellow)
Blinking Data activity
Steady On Power OK
Blinking 2x No DHCP response
Power/Diagnostic LED (Orange)
Blinking
Setup Menu active
Dimensions
The following drawing shows the dimensions of the XPress DR+
Figure 3-10. Dimensions