User's Manual
Table Of Contents
- Figures
- Tables
- Using This Guide
- Introduction
- Installation and Hardware
- XPress DR+W
- Using DeviceInstaller
- Configuration Using Web Manager
- Configuration Using Telnet or Serial Port (Setup Mode)
- Setup Mode: Server Configuration
- Setup Mode: Channel Configuration
- Channel 1 (Option 1) and Channel 2 (Option 2)
- Baudrate
- I/F (Interface) Mode
- Flow
- Port Number
- Connect Mode
- Send the Escape Sequence (+++) in Modem Mode
- Auto Increment Source Port
- Remote IP Address
- Remote Port
- DisConnMode
- Flush Mode (Buffer Flushing)
- Pack Control
- DisConnTime (Inactivity Timeout)
- Send Characters
- Telnet Terminal Type
- Channel (Port) Password
- WLAN Settings (XPress DR+W Only)
- Setup Mode: Advanced Settings
- Firmware Upgrades
- Monitor Mode
- Troubleshooting and Technical Support
- Technical Specifications
- Lantronix Cables and Adapters
- Alternative Methods of Assigning an IP Address
- Binary to Hexadecimal Conversions
- Compliance Information
- Warranty
Chapter 1: Using This Guide
XPress DR+ User Guide 4
Ad Hoc Network ________________________________________________________ 29
Serial Tunneling – Infrastructure ___________________________________________ 29
Ad Hoc XPress DR+W Connection _________________________________________ 30
Physically Connecting the XPress DR+W ________________________________ 30
Front Panel Description ______________________________________________ 31
LEDs ____________________________________________________________ 33
Required Information for Initial Configuration______________________________ 33
Hardware Address ______________________________________________________ 33
IP Address ____________________________________________________________ 33
WLAN Settings _________________________________________________________ 34
Installing the XPress DR+W for Initial Configuration ________________________ 34
Server Configuration (Option 0) ________________________________________ 34
Network Mode (XPress DR+W only) ________________________________________ 35
IP Address ____________________________________________________________ 35
Set Gateway IP Address _________________________________________________ 35
Netmask: Number of Bits for Host Part ______________________________________ 35
Change Telnet Configuration Password _____________________________________ 36
Change DHCP Device Name: _____________________________________________ 36
WLAN Configuration (Option 4) ________________________________________ 36
Topology______________________________________________________________ 37
Network Name (SSID) ___________________________________________________ 37
Adhoc Network Channel _________________________________________________ 37
WEP _________________________________________________________________ 38
WPA _________________________________________________________________ 39
WPA2/802.11i _________________________________________________________ 40
Fixed or Automatic Data Rate _____________________________________________ 40
Transmission Data Rate__________________________________________________ 40
Next Steps ________________________________________________________ 40
Chapter 5: Using DeviceInstaller 42
Installing DeviceInstaller _____________________________________________ 42
Assigning an IP Address _____________________________________________ 42
Accessing the XPress DR+ Using DeviceInstaller __________________________ 43
Viewing the Current Configuration ______________________________________ 43
Chapter 6: Configuration Using Web Manager 46
Accessing XPress DR+ Using DeviceInstaller _____________________________ 46
Network Configuration _______________________________________________ 48
Automatic IP Address Configuration ________________________________________ 48
Static IP Address Configuration ____________________________________________ 49