User's Manual
Table Of Contents
- Figures
- Tables
- Using This Guide
- Introduction
- Installation and Hardware
- XPress DR+W
- Using DeviceInstaller
- Configuration Using Web Manager
- Configuration Using Telnet or Serial Port (Setup Mode)
- Setup Mode: Server Configuration
- Setup Mode: Channel Configuration
- Channel 1 (Option 1) and Channel 2 (Option 2)
- Baudrate
- I/F (Interface) Mode
- Flow
- Port Number
- Connect Mode
- Send the Escape Sequence (+++) in Modem Mode
- Auto Increment Source Port
- Remote IP Address
- Remote Port
- DisConnMode
- Flush Mode (Buffer Flushing)
- Pack Control
- DisConnTime (Inactivity Timeout)
- Send Characters
- Telnet Terminal Type
- Channel (Port) Password
- WLAN Settings (XPress DR+W Only)
- Setup Mode: Advanced Settings
- Firmware Upgrades
- Monitor Mode
- Troubleshooting and Technical Support
- Technical Specifications
- Lantronix Cables and Adapters
- Alternative Methods of Assigning an IP Address
- Binary to Hexadecimal Conversions
- Compliance Information
- Warranty
Chapter 1: Using This Guide
XPress DR+ User Guide 5
Server Configuration ________________________________________________ 49
Host List Configuration_______________________________________________ 51
Channel Configuration _______________________________________________ 52
Serial Settings _________________________________________________________ 52
Connection Settings - TCP________________________________________________ 55
Connection Settings - UDP _______________________________________________ 57
WLAN Configuration (XPress DR+W only) _______________________________ 59
Applying Settings ___________________________________________________ 63
Applying Factory Defaults ____________________________________________ 63
Chapter 7: Configuration Using Telnet or Serial Port (Setup Mode) 64
Accessing Setup Mode ______________________________________________ 64
Telnet Connection ______________________________________________________ 64
Serial Port Connection ___________________________________________________ 65
Exiting Setup Mode _________________________________________________ 66
Chapter 8: Setup Mode: Server Configuration 67
Server Configuration (Option 0) ________________________________________ 67
Network Mode (XPress DR+W only) ________________________________________ 67
IP Address ____________________________________________________________ 67
Set Gateway IP Address _________________________________________________ 68
Netmask: Number of Bits for Host Part ______________________________________ 68
Change Telnet Configuration Password _____________________________________ 68
DHCP Name ______________________________________________________ 69
Chapter 9: Setup Mode: Channel Configuration 70
Channel 1 (Option 1) and Channel 2 (Option 2) ___________________________ 70
Baudrate _________________________________________________________ 70
I/F (Interface) Mode _________________________________________________ 71
Flow _____________________________________________________________ 71
Port Number_______________________________________________________ 72
Connect Mode _____________________________________________________ 72
a) Incoming Connection __________________________________________________ 74
b) Response ___________________________________________________________ 74
c) Active Startup________________________________________________________ 74
d) Datagram Type ______________________________________________________ 76
e) Modem Mode ________________________________________________________ 76
Send the Escape Sequence (+++) in Modem Mode ________________________ 79
Auto Increment Source Port___________________________________________ 79
Remote IP Address _________________________________________________ 79